#Huawei configuration decompressor how to#

Newly calculated one, regardless of whether the conflicting router

If the automatic recovery function is enabled and a router IDĬonflict occurs between indirectly connected routers in one OSPF area, the conflicting router ID is replaced with a.

You can configure an interface to fill in the Interface MTU field of a DD packet with the interface MTU.Īfter configuring basic OSPF functions, verify information about OSPF neighbors, interfaces, and routes.

(Optional) Configuring an Interface to Fill in a DD Packet.

You can control packet retransmission and improve the convergence rate by setting an interval at which an LSA packet is retransmitted to the neighboring router.

(Optional) Setting an Interval at Which an LSA Packet Is Retransmitted.

When no response to DD packets, LSU packets, or LSR packets is received, the retransmission mechanism is used and the maximum number of packet retransmission attempts is set to prevent dead loops caused by repeated transmissions. (Optional) Configuring the Maximum Number of Packet Retransmission.When multiple routing protocols are used to select routes, you can set the OSPF priority to maneuver route selection. You can configure the router to comply with the route selection rule defined in RFC 1583 or RFC 2328. (Optional) Configuring a Route Selection Rule on the router.

#Huawei configuration decompressor how to#

This section describes how to create logical links between backbone areas and to ensure the OSPF network connectivity. After an OSPF process is created, a router ID is configured for the router, an interface on which OSPF runs and the area to which the interface belongs are specified, routes can be discovered and calculated in the AS.